Loading ...
Loading ...
Loading ...
-15-
Operating Instructions
User Interface (GWS18V-45PSC) (see figure 2)
The user interface is used to preselect the speed and to indicate the status of the power tool.
SPEED PRESELECTION
You can use the button for speed preselection to preselect the required speed, even during
operation. The data in the following table are recommended values.
Material Application Accessory Speed preselec-
tion level
GWS18V-45PSC
[min
-1
]
Metal
Brushing, rust re-
moval
Cup brush 14500
Stainless
steel
Grinding Fibre disc 26000
Metal
Rough grinding Grinding disc 39000
Metal
Cutting Cutting disc 39000
Masonry,
stone
Cutting Diamond cutting disc and cutting guide (cutting
stone is permitted only with a cutting guide)
39000
STATUS INDICATIONS
Battery status indicator (User interface) Meaning/Cause Solution
green
Battery charged
yellow
Battery almost empty Replace or charge battery soon
red
Battery pack empty Replace or charge battery
Overload protection indicator
(User interface)
Meaning/Cause Solution
yellow Critical temperature has been
reached (motor, electronics,
battery)
Run the power tool at no load and allow it
to cool down
red
Power tool is overheated and
switches off
Allow the power tool to cool down
Power tool status indicator
(User interface)
Meaning/Cause Solution
green Status OK –
yellow
Critical temperature has been
reached or battery is almost empty
Run the power tool at no load and allow it
to cool down, or replace or charge the
battery soon
Illuminated red
Power tool is overheated or battery
is empty
Allow the power tool to cool down, or re-
place or charge the battery
Flashing red
Kickback shutdown, restart
protection has been triggered
Switch the power tool off and on again
Flashing blue
Power tool is connected to a mobile
terminal device or settings are
being transferred
–
WIRE BRUSH ASSEMBLY
Before assembling wire brush to this tool,
disconnect from the power source. Attach
hand guard (Fig. 1). Wire brushes are
equipped with their own threaded hub, simply
thread on to spindle. Be sure to seat against
shoulder before turning tool “ON”.
TO REMOVE: Reverse procedure.
WIRE WHEEL ASSEMBLY
Before assembling wire wheel to this tool,
disconnect from the power source. Attach type
27 guard (Fig. 3). Wire wheels are equipped
with their own threaded hub, simply thread on
to spindle. Be sure to seat against shoulder
before turning tool “ON”.
TO REMOVE: Reverse procedure.
160992A3WF 08-18 GWS18V-45C.qxp_GWS 8/28/18 1:07 PM Page 15
Loading ...
Loading ...
Loading ...