Loading ...
Loading ...
Loading ...
347
PO
S AVE THESE INSTRUCTIONS
(347PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 05/21/2020
English
Page 19
Turn o the spa control unit.
Remove the drain valve cap from outside of the spa tub and attach a
garden hose, point the other end of the garden hose to a suitable
draining area .
From inside of the spa tub, open the drain valve cap, water will start
owing out from the garden hose.
When the water stops draining, disconnect the spa control unit from
the spa tub wall. Lift the spa tub wall from the side opposite the drain,
leading any remaining water to the drain and emptying the spa completely
.
Attached the ination hose to the air blower ination outlet on the
control unit.
Turn on the spa and press the
button, aim the ination hose at the
inlet/outlets on the spa tub and spa control unit to dry out any water in the
piping system .
Use a clean towel to wipe up any remaining water and moisture on the
spa tub and spa control unit.
Ensure the spa tub and spa control unit are thoroughly dried.
The enclosed plugs can be used to cover the water inlet and
outlet connectors from the inside of the spa tub to prevent water from
owing out.
If dirt is visible in the water or water becomes cloudy and proper water
chemistry does not clear it up, change the water and clean the spa tub.
See “Spa Tub Drainage” section on how to drain the spa.
While empty, remove the cartridge housing from inside of the spa tub wall,
clean and/or replace the lter cartridge. Use a sponge and mild soap solution
to wipe away any soil or stains on the inside of the spa wall. Rinse thoroughly
before relling with clean water.
Do not use steel wool, hard brushes or abrasive cleaners.
See your local spa professional for biolm removal products and advice.
Check the spa tub air valve for leakage and tightness before use. If air is leaking
from the air valve, use the provided wrench to tighten the air valve as follow:
Make sure the spa tub is deated, open the air valve cap and insert the
wrench into the air valve body.
With one hand, hold the backside of the air valve base from the inside of
the spa tub wall and turn the wrenchclockwise.
Never adjust the air valve base when the spa is in use or
lled with water. Only use the air valve wrench if the air valve is loose or
there is leakage around air valve base. Do not over tighten the air valve: over tightening can damage the
valve. Just ensure the air valve is snug and not leaking.
MAINTENANCE
Loading ...
Loading ...
Loading ...