Ancona AN1297 User Manual

Loading ...

— 13 —

STEP 11

Venting

• Depending on exterior ventilation chosen (see page 10), either exit the ducting through the ceiling or wall.

• Alwaysuserigidtypemetal/aluminumducttube(followthebuildingcodesinyourarea)tomaximizeairow.Makesure

thatthebackdraftapscanopen,toallowmaximumairow.Connecttheducttubetothevent/damperandsecurely

seal with certied aluminum or foil tape so that it is air tight. Please check the building codes in your city to learn which

tape product is recommended.

IMPORTANT:

• Observeallgoverningcodesandordinances.

• It is the customer’s responsibility to contact a qualified electrical installer.

• Ifcodespermitandaseparategroundwireisused,itisrecommendedthataqualifiedelectriciandeterminethat

thegroundpathisadequate.A120-Volt,60Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-amp

circuit, fused on both sides of the line.

• DONOTgroundtoagaspipe.

• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.

• DONOThaveafuseintheneutralorgroundcircuit.

IMPORTANT: Save this Installation Guide for electrical inspector’s use.

GROUNDING INSTRUCTIONS:

• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric

shock by providing an escape wire for the electric current.

• Thisapplianceisequippedwithacordhavingagroundingwirewithagroundingplug.Theplugmustbeplugged

into an outlet that is properly installed and grounded.

WARNING: Improper grounding can result in a risk of electric shock.

• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto

whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,

have a qualified electrician install an outlet near the appliance.

• Therangehoodmustbeconnectedwithcopperwire/plugonly.Therangehoodshouldbeconnecteddirectlyto

the fused disconnect (or circuit breaker) box through flexible armored or non-metallic sheathed copper cable. UL/

CSA listed strain relief must be provided at each end of the power supply cable. Use only with range hood cord-

connection kits that have been investigated and found acceptable for use with this model.

Installation

Loading ...

Ancona AN1297 30 Inch Stainless Steel Ducted Standard Hood Under Cabinet Hood