Loading ...
Loading ...
Loading ...
PROGRAMMING
NOTICE: If this Security_ "®garage door opener is operated with a non-rolling code remote control, the technical
measure in the receiver of the garage door opener, which provides security against code-theft devices, will be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the
non-rolling code remote control to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional 315 MHz Security÷® remote controls.
To Add or Reprogram a Hand-held Remote Control
USING THE "LEARN" BUTTON USING THE MOTION DETECTING DOOR CONTROL
CONSOLE
1. Press and release the "learn" button
on the motor unit. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
\1 /
1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the
Motion Detecting Door Control.
3. Continue holding both buttons while
you press the push bar on the Motion
Detecting Door Control (all three
buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
\1 /
To Erase All Codes From Motor
Unit Memory
Press and hold the "learn" button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All
previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.
To deactivate any unwanted remote, first erase all codes:
J
37
*3-Button Remotes (315 MHz)
If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on
any Security÷ ® 3-button
remote or mini-remote can
be programmed to operate
other Security÷ ¢ garage
door openers.
Loading ...
Loading ...
Loading ...