Loading ...
Loading ...
Loading ...
Controlsand Features
4
f
Muffler
Air Filter
Choke
Throttle
OiJDrain
Fuel Fill l
Recoil Starter
Handle
OiJDrain
NOTE: Engine models may vary in features and/or location of
controls. The following is to serve as a general reference. Always
supplement this information with the operator's manual that
is included with the product for more information regarding
specific controls and their location.
ChokeControl
Activating choke control by sliding it all the way to the right
closes the choke plate on carburetor and aids in starting engine.
For information on choke usage, see "Starting The Engine".
The image above corresponds with the label on the engine
identifying the Choke control.
RecoilStarter& Starter Handle
This motor is fitted with a recoil action pull start and a mitten
grip handle for easy access while wearing gloves or mittens.
Figure 4-1
Ignition Key
NOTE:The existence and location of an ignition key may vary by
product. Refer to your product operator's manual for specific key
inclusion and/or location information.
Insert the key, if so equipped, and snap it into place; do not turn
the key to attempt to start/stop the unit. Pull the key out halfway
to stop the engine. Remove key when the unit is not in use.
Oil Fill
On some models the oil fill is located at the top of the engine, as
seen in the lower portion of Fig. 4-1. On some other models, it is
located on the bottom of the engine block as seen in the upper
portion of Fig. 4-1. Remove oil cap to add oil. Refer to "Pre-
Operation Check" section for checking oil and "Maintaining Your
Engine" section for adding oil instructions.
Loading ...
Loading ...
Loading ...