Ancona AN1251 User Manual

Loading ...

— 16 —

IMPORTANT:

• Observeallgoverningcodesandordinances.

• It is the customer’s responsibility to contact a qualified electrical installer.

• Ifcodespermitandaseparategroundwireisused,itisrecommendedthataqualifiedelectriciandeterminethat

thegroundpathisadequate.A120-Volt,60Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-amp

circuit, fused on both sides of the line.

• DONOTgroundtoagaspipe.

• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.

• DONOThaveafuseintheneutralorgroundcircuit.

IMPORTANT: Save this Installation Guide for electrical inspector’s use.

GROUNDING INSTRUCTIONS:

• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric

shock by providing an escape wire for the electric current.

• Thisapplianceisequippedwithacordhavingagroundingwirewithagroundingplug.Theplugmustbeplugged

into an outlet that is properly installed and grounded.

WARNING: Improper grounding can result in a risk of electric shock.

• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto

whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,

have a qualified electrician install an outlet near the appliance.

Installation

STEP 13A (wall hoods only)

Install Chimney

• Place chimney on top of the main housing

• Remove the protective coating from the upper

chimney. Carefully slide the upper chimney down

into the lower chimney. Make sure upper chimney is

moving freely.

• Hook lower chimney bracket to lower chimney, then

screws the lower chimney bracket on wall. (See

Figure #5)

• Screw the upper chimney to the upper mounting

bracket. (See Figure #6)

Fig. #6Fig. #5

STEP 14A (wall hoods only)

Install Filters

To install lters see the following four steps (See Figure #7):

• Angle the lter into slots at the back of the hood.

• Push the button on handle of the lter.

• Release the handle once the lter ts into a resting position.

• Repeat to install all lters.

Fig. #7

Loading ...

Ancona AN1251 30 Inch Stainless Steel Convertible Standard Hood Under Cabinet Hood