Honeywell HPA300-PFBUNDLE OWNER'S MANUAL

Loading ...

MAINTAINING YOUR STAGE 1WASHABLE PARTICLE PREFILTER

REPLACING THE CERTIFIED HEPA FILTERS

Remove and dispose of used filters. Avoid breathing dust when changing filters

See INSTALLATION INSTRUCTIONS on page 4 of this manual.

Please note that each model series takes a different number of HEPA Filters: HPA090 and HPA100 Series use

1 Certified HEPA

Filter

Replacement Filter, HPA200 Series use 2 Certified HEPA

Filter

Replacement Filters , HPA300

Series use 3 Certified HEPA

Filter

Filters.

See ACCESSORIES AND REPLACEMENT FILTERS section on page 7 of this manual to find out where to get filters.

There are stickers inside your air purifer near the filter cavity that note the Filter Type needed for your model.

These air purifier models each have two electronic filter checks to remind you when

to check and replace the Certified HEPA Filters and the Odor Reducing PreFilters based

on the air purifier’s hours of use.

When the Certified HEPA Filter(s) and/or the PreFilter need to be replaced, the

“Check Filter” or “Check PreFilter” light will illuminate (Fig. 7).

You should periodically check these filters. Depending on operating conditions, the

Certified HEPA Filters should be replaced every 12 months, and the Odor Reducing

PreFilters every 3 months, especially if there have been heavy odors and particles in the

home.

To RESET Either Electronic Filter Check:

After you have replaced the appropriate filter(s) the “Check Filter or “Check PreFilter” light will remain on until it

is reset. With the unit powered on, press the lighted button and hold for approximately 2 seconds until the light

turns off. The electronic filter check is now reset. Depending on individual usage (environment and hours used),

you may need to replace filters more or less frequently.

NOTE: If you change the pre-filter or filter before the Electronic Filter Check lights are illuminated, it is possible to

reset the light indicators. With the unit plugged in, but NOT powered on, press and hold each button individually

for at least 5 seconds. This will illuminate the indicator light. After the light turns on, individually press and hold

the “Check Filter” or “Check PreFilter” button until each light goes off. At this point, the filter indicator will be

reset to it’s original “clean” status.

These cleaning intervals are intended as guidelines only. Performance of any filter media is dependent upon the

concentration of particles going through the system. High concentrations of particles such as dust, pet dander

and smoking will reduce the useful performance of the filter.

NOTE: None of the filters are washable. DO NOT immerse them in water.

WARNING: Filters may be harmful if ingested. Avoid breathing dust when changing filters.

ELECTRONIC FILTER CHANGE REMINDER

Fig. 7 Will illuminate

when it is time to

change HEPA filters

The Odor Reducing PreFilter not only helps reduce odors, but also helps capture large airborne particles that

enter the grille. This pre-filter should be replaced every 3 months, as it will become covered with particles and

fibers that will reduce filtration performance. Avoid breathing dust when changing filters.

See INSTALLATION INSTRUCTIONS on page 4 of this manual.

Use the specially designed Type

Pre-Filter

Odor Reducing PreFilter.

To purchase additional

Pre-Filter

PreFilters, see ACCESSORIES AND REPLACEMENT FILTERS section on page 7.

REPLACING THE ODOR REDUCING PREFILTER

Loading ...

Honeywell HPA300-PFBUNDLE Air Purifier + 1 Full Year of Filters Special Offer

OWNER'S MANUAL - Page 6