Loading ...
Loading ...
Loading ...
9
USING THE APPLIANCE
NOTE:
- Use the lower mounting slots (12) when using large mugs and the upper
mounting slots (12) when using small cups.
- When removing the water reservoir (3) close the lid (2).
t Lift the water reservoir (3) and remove it from the appliance. Remove the lid from
the water reservoir (3).
t Fill the water reservoir (3) with fresh cold water (ill.
g
) and then refit the water
reservoir (3) with lid afterwards.
WARNING:
- Do not over or under ll the water reservoir (3). Ensure the water level is always
between the Min and Max marking on the water level indicator (4) (ill.
g
).
Remove the water reservoir and drain excess water if needed.
t Securely place a cup/mug in the center of the cup holder (10) (ill.
h
).
t Insert the plug (5) into a wall outlet (ill.
i
). All indicator lights will flash 3 times,
followed by the appliance switching to stand-by mode with all indicator lights off.
Brewing
t Either press the GROUND button (9) or CAPSULE button (8) according to the
t Press the cup SIZE button (7) until the indicator light for the desired volume is
illuminated the brew volume will increase by 2oz with each press. After 5 seconds
t
GROUND button (9) or
CAPSULE button (8)
brewing
process with 6oz
cup
.
NOTE:
Alternatively, first press the cup - SIZE button (7) until the indicator light for the
desired volume is illuminated and then press either the GROUND button (9) or
CAPSULE button (8) according to the type of coffee to be brewed.
- If no action is done within 30 seconds after the volume selection, all indicator
lights (6, 7, 8, 9) will switch off and the appliance will switch to stand-by mode.
Restart previous steps (
Brewing).
- You can stop the brewing process at any time by either pressing the CAPSULE
button (8) or GROUND button (9) according to the type of coffee being
brewed.
- During the brewing process, pressing the cup SIZE button (7) will have no
effect, as the set volume cannot be modified after brewing has started.
- If the water reservoir (3) is empty from the start or empties during the brewing
process, the appliance will stop heating and all indicator lights (6, 7, 8, 9)
switch off after a few seconds. After refilling water to re-start brewing, the unit
will take 2 to 3 minutes before brewing to protect itself.
appliance will st
seconds after the
brew type
selection either press
the
then
the
appliance
will
the
.
,
,
type of coffee to be brewed.
ar
t the brewing process
If no action is done within 5
st
ar
t
size
,
The appliance
will now start the brewing process
.
the
Loading ...
Loading ...
Loading ...