Loading ...
Loading ...
Loading ...
en Faults and what to do about them
46
Information on the display panel
Faults and what to do about them
Fault code
‹˜“¯ The door is not properly closed. Close the door.
“‚ The water control system has been activated. Disconnect the appliance from the
mains, turn off the tap and advise the after-sales service.
Ҡ Water is not entering the appliance. See the fault Water is not flowing in
“‡ ˜—¯˜ The water is not Drained. See the fault Water is not Drained
—Ÿ –©‘š Not a fault! The unbalanced load detection system has detected an unbalanced
load caused by laundry items. The fluff removal cycle cannot start. Remove the
laundry.
•‚ “Ÿš
–‹ “Ÿš
Maximum or minimum drying load not taken into account. HI/End or LO/End
flash alternately in the display. See information for the Drying result not satisfac-
tory fault..
Other fault codes are only for use by the after-sales service. Make a note of the fault code to inform the
after sales service.
Fault Possible cause Remedial Action
Programme does not
start
The Start/Pause I button has not
been pressed.
Press the Start/Pause I button.
A delayed start time has been selected.. Washer dryer starts on completion
ofthe delay period. Change the “finished
in time” if necessary.
Power cut.The delayed start time that
was selected has been cleared.
Reselect the delayed start time or start-
the programme immediately. Press the
Start/Pause I button.
The door is not properly closed. Close the door.
Plug not inserted properly into socket. Insert plug correctly
The maximum spin
speed cannot be set.
The maximum spin speed depends on
the programme selected.
Change programme as required.
The water is not
Drained.
Drain hose is twisted.. Fit the Drain hose correctly.
Detergent pump is blocked. Clean the Drain pump .
Detergent residues in
the detergent drawer.
Damp or lumpy detergent. Clean and dry the detergent drawer .
Use the measuring aid for liquid deter-
gent.
Loading ...
Loading ...
Loading ...