DRAPER 24276 User Manual

Loading ...

5. Health and Safety Information 5. Health and Safety Information

– 6 – – 7 –

5.3 Correct Use of the Jack

Important: The jack is a lifting device ONLY and should

never be used to move the vehicle. The vehicle to be

lifted should never exceed the rated capacity of the jack.

• ALWAYS bleed the jack piston before use.

• ONLY operate the jack on solid, level and horizontal

surfaces.

− A concrete surface is recommended,

where possible.

− All four wheels of the jack should be in contact

with the operating surface when in use.

WARNING! Never use the jack on any surface that is

slippery or may sink or rock.

• When positioning the jack, ALWAYS use the

manufacturer’s recommended lifting point.

− These points vary between vehicles; consult the

manufacturer’s manual or the Haynes workshop

manualforthespecicvehicleinformation.

• Ensure that the lifting point is not dirty, greasy or

corroded.

• The lifting point must remain centred over the saddle

duringraisingandlowering;o-centredloadsmay

slip and cause injury.

• Position the jack so that no part of the operator is

required to be underneath the vehicle at any time

during lifting or lowering.

• Keep clear of all movable parts of the jack mechanism

when in use.

• Topreventoverloading,thejackisttedwithan

overload valve set at the factory.

Important: The overload valve should not be adjusted

under any circumstances. If the capacity of the jack is

exceeded, the valve will prevent the lifting operation.

• Take all precautions to prevent movement of the

vehicle during raising and lowering.

− Beawarethattracandotherexternalforcesmay

cause the load to rock if used at the roadside.

• Remain alert and observe the load at all times during

operation.

− Should any dangerous conditions occur, including

unexpected movement of the vehicle, cease all

operationuntiltheseconditionshavebeenrectied.

• NEVER work under a raised vehicle without using the

correct axle supports or other appropriate supporting

methods.

• DO NOT enter the vehicle or start the engine while it is

supported on the jack or axle stand.

• NEVER leave the jack unattended when in use.

• NEVER detach the handle shaft while the jack is

under load.

• ALWAYS ensure that there are no persons or

obstacles beneath the vehicle before lowering.

Important: Read all Health and Safety instructions

before attempting to operate, maintain or repair this

product. Non-compliance with these instructions may

result in injury or damage to the user, the product or the

vehicle to be lifted. Draper Tools accepts no

responsibility for improper use of this jack.

5.1 General Health and Safety

Precautions

• Only authorised personnel who have carefully read

and understood this manual should operate this

product.

• Always wear adequate protective footwear when using

the jack.

• Always ensure that the working area is well

illuminated and free from obstructions.

• Keep bystanders at a safe distance during operation.

• Allow a minimum distance of 0.5m between the

vehicle and surrounding objects to allow the vehicle

to tip when lifted.

• The wheels of this product DO NOT lock.

− Ensure that the jack will not roll once positioned

for use.

• Care must be taken when handling and lifting.

− Dropping the jack may result in damage to the

product or personal injury.

• DO NOT modify this product in any way.

• Stay alert to external interference that may cause the

raised load to rock during preparation and operation.

• When not in use, lower the lifting arm, put the handle

shaft into an upright position and twist it clockwise

until strong resistance is felt.

− This prevents the handle shaft from creating a trip

hazard and holds it in the upright position.

− Alternatively, lower the lifting arm, remove the

handleshaftandlayitatontheoor.

• This jack does not emit noise that exceeds a level of

70dB(A) during operation.

5.2 Preparing the Vehicle to be Lifted

WARNING! DO NOT lift the vehicle if it may result in the

spillage of dangerous substances, including fuel or

battery acid.

• Ensure that there is no one inside the vehicle.

• Switchotheengineandapplythehandbrake.

• Put the vehicle into gear (for manual transmission) or

“Park” (for automatic transmission).

• Take any necessary precautions to prevent the vehicle

from sliding.

− Grounded wheels should be securely blocked with

wheel chocks (Stock No. 54500).

Loading ...

DRAPER 24276 Expert Professional Low Profile Garage Trolley Jack, 4 Tonne

User Manual - Page 4