Loading ...
Loading ...
Loading ...
8 9
CUTTING HAIR
The first time you cut hair, cut only a small amount until you become
accustomed to how long each guide leaves the hair. Depending on
your model, the following guide combs may be included in your kit.
Always start by placing the largest guide comb on the clipper, then
use shorter combs if desired length is shorter.
Guide Comb #1—leaves hair approx. 1/8”
Guide Comb #2—leaves hair approx. 1/4”
Guide Comb #3—leaves hair approx. 3/8”
Guide Comb #4—leaves hair approx. 1/2”
To attach combs, hold comb with teeth up and snap it firmly to the
bottom of the clipper blade.
For uniform cutting, allow the clipper to cut its way through the hair.
Do not force it through at a faster rate.
TIPS FOR ALL BREEDS OF DOGS
For specific breeds go to youtube.com/WahlHomeProducts
1) Before clipping your puppy for the first time, run the clipper near
the puppy’s ear for a short time so he gets used to the noise.
2) If clipping for the first time, the clipping process will be slow. Try
to move with the dog when clipping. After a few grooming sessions,
you will develop your own comfortable style and grooming will go
faster.
3) Take your time when grooming, and use a lot of affection. Dogs
know when you’re in a hurry and will react by getting nervous, making
grooming more difficult.
4) It is very important to trim out excess hair on the pads. Otherwise
the pads will become dirty and matted, causing painful walking for
the dog.
TROUBLESHOOTING
If your clipper does not seem to take a charge, check the following
before returning it for repair:
1. Check outlet operation by plugging in another appliance.
2. Make sure the outlet is not connected to a switch which turns the
power at the outlet off.
3. Be sure the clipper is properly connected to the recharging
transformer, all connections are secure and the switch on the
clipper is turned “OFF - 0.”
4. If your electricity is connected to a master power switch, we
suggest the clipper be disconnected from the charger anytime the
master switch is off. Leaving the unit plugged into a dead outlet
or an unplugged charger will drain the battery. Prior to storing,
disconnect recharging transformer from the unit.
5. If clipper does not run and it is completely charged, turn the unit
“ON - I” and pinch or push the blades manually. (Oil may have
dried out between the blades, so they may be temporarily stuck
together.)
SAVE THESE INSTRUCTIONS
This Clipper Has Been Designed For
THIS APPLIANCE IS INTENDED FOR
Loading ...
Loading ...
Loading ...