Loading ...
Loading ...
4 5
CONTAINS SEALED, RECHARGEABLE NICKEL METAL
HYDRIDE BATTERY. MUST BE RECYCLED OR
DISPOSED OF PROPERLY.
The RBRC Battery Recycling Seal on the nickel metal hydride (NiMH) battery
contained in this product indicates Wahl is voluntarily participating in an
industry program to collect and recycle these batteries at the end of their useful
life, when taken out of service in the United States or Canada. The RBRC
program provides a convenient alternative to placing used NiMH batteries into
the trash or the municipal waste stream, which is illegal in some areas. Please
call 1-800-8-BATTERY for information on NiMH battery recycling in your area.
Wahl’s involvement in this program is part of our commitment to preserving
our environment and conserving our natural resources.
NiMH
BATTERY TYPE: NICKEL METAL HYDRIDE:
Model: 9649
RECHARGEABLE CORD/CORDLESS OPERATION
1. Before use, the clipper must be fully charged for 12 to 15 hours.
2. Once fully charged, the unit may be used without cord. A fully charged
clipper can deliver up to 60 minutes of continuous use.
3. After use, move the on/off switch to the “O” (OFF/CHARGE) position.
Reconnect the clipper to the cord and recharge batteries by connecting the
cord into any convenient electrical outlet.
NOTE: If the batteries have completely run out, the clipper can be used as a corded
clipper (see the following “corded operation”).
CORDED OPERATION
1. Be sure the on/off switch is in the “O” (OFF) position.
2. Connect the clipper to the cord, and plug it into an electrical outlet.
3. Move the on/off switch to th “1” (ON) position.
4. After use, disconnect cord from outlet.
CLIPPER/RECYCLING OF BATTERIES
Depending on use, your batteries should last five years. At the end of its life,
when it can no longer take a full charge, it cannot be replaced. The clipper must
be discarded, but first the battery must be removed & recycled properly. To do
so, follow these steps.
1. Make sure the on/off switch is in the “0” (OFF) position and that the cord is
NOT plugged into the clipper or any electrical outlet.
2. Remove blade assembly from clipper and remove screws and cover plate.
3. Remove cover plate by releasing visible cover “hooks” and pulling cover
away.
4. Locate circuit board and battery and cut negative end of battery away from
circuit board then positive end.
5. Apply tape to both ends of the battery before recycling or properly
disposing of it.
Loading ...
Loading ...
Loading ...