Frigidaire GLEF389GBA Electric Range

Use & Care Manual - Page 27

For GLEF389GBA.

PDF File Manual, 32 pages, Read Online | Download pdf file

GLEF389GBA photo
Loading ...
Loading ...
Loading ...
Thetemperatureintheovenhasbeenpre-setatthefactory.Whenfirstusingtheoven,be
suretofollowrecipetimesandtemperatures.If you think the oven is too hot or too cool, the
temperature in the oven can be adjusted. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The baking
results should help you to decide how much of an adjustment is needed.
Note: The oven
temperature adjustments
made with this feature will
not change the Self-Clean
cycle temperature.
INSTRUCTIONS
To adjust the oven temperature higher:
1. Press for 6 seconds (Fig. 1).
2. To increase the temperature use the number pads to enter the
change. (Example30°F) (_(_ (Fig. 2).
desired The
temperature may be increased as much as 35°F (19°C).
3. Press t to accept the temperature change and the display
return to the time of day (Fig. 3). Press @ to reject
will the
change if necessary.
PRESS
©
DISPLAY
Fig. 1
Fig. 2
To adjust the oven temperature lower:
1. Press q for 6 seconds (Fig. 4).
2. To decrease the temperature use the number pads to enter the
change. (Example-30°F) (_ (_) and then press
desired
_ (Fig. 5). temperature may as as
The be decreased much
35°F (19°C).
3. Press q to accept the temperature change and the display
return to the time of day (Fig. 6). Press @ to reject
will the
change if necessary.
©
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Oven
Wire
Holder
Changing the Oven Light
The oven light bulb is located at the rear of the oven and is covered with a glass shield held by
a wire holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light bulb:
1. Turn electrical power off at the main source or unplug the range.
2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock will then need to be reset. To reset, see Setting the Clock.
Be sure the range is unplugged and all parts are COOL before replacing oven
light. Wear a leather-faced glove for protection against possible broken glass.
27
Loading ...
Loading ...
Loading ...