Loading ...
Loading ...
Loading ...
1- Rotate the function selector to the position " ". On the display, appears the indication " ECO " or
" SUP ". The preset time is 90 min, this can be varied from 90 min (Eco mode) to 120 min (Sup mode) via
the programmer (setting button " + " or " - "). If the oven is very dirty, it is recommend o increase the time
to 120 min, if the oven is moderately dirty reduce the cleaning cycle time to 90 min.
2- It is possible to defer the start time of the pyroclean cycle by changing the END time via the
programmer.
3- After few minutes, when the oven reaches a high temperature, the door locks automatically. The
pyroclean cycle can be stopped at any time by turning the function selector back to '0' (the word OFF will
be displayed for 3 seconds).
4- Once the pyroclean cycle is finished, the pyrolysis will switch off automatically. On the display appears
the indication "END" until the door is locked then "0--n".
5- You can turn the function selector back to " 0 " but if the temperaure is still high, the "0--n " indication
appears to inform that the door is locked.
Using the pyrolitic cycle:
Use of the pyrolytic cycle in Touch Control ovens:
1- Rotate the function selector into position pyrolisys. The display will show either "ECO" or "SUP“
2- The pre-set time is90 minutes but it can be varied from 90 min. (Eco mode) to 120 min. (Sup mode)
using the programmer (" +" or "-" key). If the oven is very dirty, the time should be increased to 120 min.,
while if the oven is only a slightly dirty, reduce the cleaning cycle to 90 min.
EN 30
4.3 Aquactiva Function
Care must be taken with all hot surfaces as there is a risk of burns. Use distilled or drinkable water.
3. Set the temperature to the Aquactiva icon
4. Allow the program to operate for 30 minutes.
6. When the appliance is cool, clean the inner surfaces of the oven with a cloth.
1. Pour 300 ml of water into the Aquactiva container at the bottom of the oven.
The Aquactiva procedure uses steam to help remove remaining fat and food particles from the oven.
Warning:
2. Set the oven function to Static ( )or Bottom ( )heater
Make sure that the appliance is cool before you touch it.
5. After 30 minutes switch off the program and allow the oven to cool down.
N.B.: Certain pyrolytic ovens with the Precò Touch User Interface offer the Aquactiva function. To
activate it, set the function selector to the AQUACTIVA symbol ( ) and set the oven temperature
to 90°, using the “-” and “+” keys.
300 ml
Loading ...
Loading ...
Loading ...