Loading ...
Loading ...
Loading ...
9
Fig. 1
Front
Panel
Insulation
Panel
Top Panel
Side Panel (R)
B. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the appliance,
it will not work properly.
• See the nameplate on the rear panel, and check that your voltage supplied corresponds
with the voltage specied on the nameplate.
• Remove the panels to prevent damage when installing the appliance. See "II.C. How to
Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic lm from the panels. If the appliance is exposed to the
sun or to heat, remove the lm after the appliance cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• The icemaker can be installed on a storage bin 30" wide or wider. Hoshizaki Ice Storage
Bins, Model B-500 series is recommended. For further options, contact your local
Hoshizaki distributor.
Model Number Bin Width Recommended Hoshizaki Ice Storage Bin
KM-1100MAJ50 30" or Wider B-500 Series
For further options, contact your local Hoshizaki distributor.
C. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and
pull towards you.
• Top Panel: Lift up at front slightly, push
rearward and lift off.
• Right Side Panel: Remove the screw. Slide
forward slightly and lift off.
• Insulation Panel: Lift up slightly, and pull
towards you.
Loading ...
Loading ...
Loading ...