Loading ...
Loading ...
Loading ...
30
CAUTION
To reduce the risk of fire, only connect your charger to a circuit with a branch circuit over-
current protection of 125% of the selected maximum amperage setting of the device in
accordance with ANSI/NFPA 70 (US) CSA C22.1 (Canada).
Installing the Holster
NOTE
The procedures below are only applicable for the “Separate Holster” model.
Place the holster on a location where no tension is applied to the charging cable.
1. Place the wall dock on the wall and level it using a spirit level.
2. Mark the three mounting holes (I) with a pencil and drill three 5/16" holes.
3. Insert three 5/16" diameter wall anchors (J) into the holes.
4. Attach the wall dock to the mounting location by screwing three M6 x 50 screws (K) into
the holes. Tighten the screws using the screwdriver type PH2.
Loading ...
Loading ...
Loading ...