Loading ...
Loading ...
Loading ...
SERVmCE AND ADJUSTMENTS
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 31)
' i ill ll,n i i,lll i
TO REPLACE HEADLIGHT BULB
o Raise hoo&
• PuLlbulb holder' out of the hole in the backside of the
grJE
- Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
o Close hood.,
tf your battery is too weak to start the engine, it should be
recharged.. If "jumper Cables" are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR TRACTOR tS EQUIPPED WiTH A 12
VOLT NEGATIVE GROUNDED SYSTEM THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM, DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES
TO ATTACH JUMPER CABLES -
= Connect each end of the RED cable to the POSITIVE
(+) terminat of each battery, taking care not to short
against chassi&
° Connect one end of the BLACK cable to the NEGA-
TIVE (-) terminal of fully charged battery.
= Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tank and battery°
TO REMOVE CABLES, REVERSE ORDER -
• BLACK cable first from chassis and then from the fully
charged battery_
o RED cable last from both batteries.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.,
• Check wiring.. See electrical wiring _iagram in the
Repair Parts section of this manual,
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse, The
fuse holder is located behind the dash°
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 32)
o Raise hood.
° Unsnap headlight wire connector,,
° Stand in frontoftractor_ Grasp hood atsides, tilttoward
engine and lift off of tractor_
° To replace, reverse above procedures.
POSITIVE TERMINAL
POSITIVE TERMINAL
NEGATIVE TERMINAL
CHARGED
BATI'ERY
NEGATIVE TERMINAL
\ \
\
£
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 32
FIG. 31
26
Loading ...
Loading ...
Loading ...