Loading ...
Loading ...
Loading ...
86 GETTING TO KNOW YOUR VEHICLE
If snow, ice, mud, or any foreign substance
builds up on the camera lens, clean the lens,
rinse with water, and dry with a soft cloth. Do not
cover the lens.
Turning Cargo Camera On Or Off — With
Uconnect 5/5 NAV
1. Press the Controls button located on the
bottom of the Uconnect display.
2. Press the Cargo Camera button to turn the
Cargo Camera system on.
NOTE:
Once initiated by the Cargo Camera button, the
Cargo Camera image will be displayed until the
vehicle speed remains below 8 mph (13 km/h)
and the 10 second timer runs out. The image may
be deactivated by pressing the X button, placing
the ignition in the OFF position, placing the gear
selector in PARK, or pressing the image defeat X
button. On deactivation, the previous selected
screen will appear.
BED RAIL TIE-DOWN SYSTEM —
I
F EQUIPPED
NOTE:
This feature is only available for vehicles equipped
with a RamBox.
There are two adjustable cleats on each side of the
bed that can be used to assist in securing cargo.
Adjustable Cleats
Each cleat must be located and tightened down in
one of the detents, along either rail, in order to
keep cargo properly secure.
To move the cleat to any position on the rail, turn
the nut counterclockwise several turns. Then pull
out on the cleat and slide it to the detent nearest
the desired location. Make sure the cleat is seated
in the detent and tighten the nut.
Adjustable Cleat Assembly
CAUTION!
The maximum load per cleat should not exceed
250 lb (113 kg) and the angle of the load on
each cleat should not exceed 45 degrees above
horizontal, or damage to the cleat or cleat rail
may occur.
1 — Utility Rail Detent
2 — Cleat Retainer Nut
3 — Utility Rail Cleat
22_DJD2_OM_EN_USC_t.book Page 86
Loading ...
Loading ...
Loading ...