Loading ...
Loading ...
Loading ...
SERVICING AND MAINTENANCE 413
4. Reach behind the headlamp and disengage
the access cover by rotating counterclockwise.
5. Disconnect the internal lamp wiring harness
connector from the high beam bulb.
6. Rotate the bulb counterclockwise a quarter
turn to unlock the bulb from the lamp.
7. Pull the bulb straight out from the housing.
8. Reverse the procedure for installation of new
bulb and covers.
Outer Front Park And Turn
See the following steps to replace:
1. Open the hood.
2. Disconnect and isolate the negative battery
cable.
3. Reach into the front wheel house ahead of the
front wheel, remove the fastener, and lift the cover
over the access hole in the front of the wheel
house splash shield. Access to the rear of the lamp
can be gained through this access hole.
Splash Shield Access Cover
4. Reach through the access hole of the wheel
house splash shield and disengage the side
marker socket by rotating counterclockwise a
quarter turn.
Park And Turn Sockets
5. Pull the socket and bulb straight out from the
housing.
6. Separate the bulb from the socket without
twisting.
7. Reverse the procedure for installation of new
bulb and covers.
CAUTION!
Do not contaminate the bulb glass by touching
it with your fingers or by allowing it to contact
other oily surfaces. Shortened bulb life will
result.
Always use the correct bulb size and type for
replacement. An incorrect bulb size or type
may overheat and cause damage to the lamp,
the bulb socket, or the lamp wiring.
8
22_DJD2_OM_EN_USC_t.book Page 413
Loading ...
Loading ...
Loading ...