GE - General Electric JGBS23BEH3BB GE gas range

User Manual - Page 18

For JGBS23BEH3BB.

PDF File Manual, 48 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Care and cleaning of the range.
Usea sewing needle or twist-tie
to unclog the small hole h7the
burner head.
Burner Caps and Heads (onsealedburnersonly)
NOTE: Before removing the burner caps
and heads, remember their sloe and location.
Replace them in the same location after
cleaning.
Burner caps
I.ifl off when cool. _,Vash 1)urner caps
in hot, soapy water and rinse with clean
water: You me} scour with a I)lasfic scouting
pad to remoxe burned-on food particles.
Burner heads
For proper ignition, make sm'e the
small hole in the secdon that fits oxer the
electrode is kept open. A ,sewino_needle
or wire twist-tie works well to tmclo_* it
Theslits in the burnerheads must be keptclean
at aft times for an even, unhamperedflame.
Replacement
Replace bm'ner heads over the electrodes
on the cooktop, in the correct locations
according U) flmir size.
Mediumhead Smallhead
Mediumhead Large head
(:logged or di m' bm'ner po_*s or electrodes
_ill not allow the burner to operate properly:
Any spill on or arotmd an electrode must
be careflfll} cleaned. Take care to not hit an
electrode with an}{hing hard or it could
be damaged,
You should dean the burner caps and
bm'ner heads routinely, especially alter bad
spillove_, which could clog the openings
in the bm'ner heads, i,ifl offwhen cool.
Make sure the slot in the bm'ner head is
positioned over fl_e electrode.
To remove burne&on fl)od, soak the
bm'ner heads in a solution of mild liquid
detergent and hot water fi)r 20-30 minutes.
For more stubborn stains, use a toothbrush.
After cleaning
Before putting the bm'ner caps and heads
back, shake out excess water and then (h')
them thoroughl) b) setting in a xwmn oxen
fi)r 30 minutes.
NOTE: Do not use steel wool or scouringpowders
to clean the burners.
Replace the matching size caps onto the
heads. There is one small, two medium
and one lmge cap. Sizes are stamped into
the bottom of the caps.
i!ii iii Smi"iii
I i
Mediumcap Largecap
Make sure that the heads and caps are
replaced in the correct locations.
NOTE: Onsome models, theburnersare a// the
same sizeand powe_
18
Loading ...
Loading ...
Loading ...