Loading ...
Loading ...
Loading ...
1. Always use the remote intake filter option when possible. This will extend the
service life of your compressor.
2. If noise reduction from vibration is desired, using the remote mount option for the
inlet filter can reduce operation noise by up to 25%.
3. Always mount the compressor at a point higher than the inlet port of the tank. This
will keep moisture from being able to seep back to the tank.
4. When mounting the compressor, use a paint pen on the rubber isolators and cover
the side to go against the chassis or mounting location. Then, simply stamp the
compressor against the chassis to make an imprint of exactly where to drill the
mounting holes for the compressor.
Pressure Switch with Relay Installation
Your VIAIR Constant Duty Onboard Air System comes complete with a pressure switch
with relay that will turn on the compressor at 165 PSI, and off at 200 PSI. The
pressure switch has a 1/8” NPT inlet at the bottom that will need to have the supplied
1/8” female to 1/4” male reducer fitting installed (using thread sealant) to allow it to
be plumbed directly to your air tank. (Use contents of Package # 3)
Pressure Switch with Relay Installation Tips
1. Never install your pressure switch in direct line from the inlet port coming from
the compressor. Tank pressure can be misread by the pressure switch. Instead, mount
the
Loading ...
Loading ...
Loading ...