Loading ...
Loading ...
Loading ...
• Use this compressor with 12-volt DC systems only.
• This product should never be left unattended during use.
Guidelines for Selecting Mounting Location:
The selection of proper mounting location for your air compressor will help ensure a
long and trouble free compressor service life. Please pay close attention to the
following:
• Select a flat & secure location where the compressor can be mounted upright.
• To maximize air compressor performance, locate compressor as close to the battery
as possible so that length of positive lead wire required is at a minimum.
• Choose mounting location that is as cool as possible and away from heat sources.
• This compressor is moisture & dust resistant, but NOT WATERPROOF or DUSTPROOF. Do
not mount compressor in locations where the unit is likely to come in contact with
water or excessive dirt.
• For compressor with remote filter mounting, select compressor’s mounting location
where air line can be routed from compressor air inlet to remote inlet air filter. Make
sure that the remote inlet air filter is located in a dry location, away from water.
• You will also want to select a compressor mounting location where the leader hose
bracket can be mounted to secure the 2 ft. leader hose.
• If it is necessary to mount the air compressor further from the battery, such as
inside your vehicle or in the bed of your pickup, use a minimum 8 AWG positive lead wire
for remote installation.
• Do not mount compressor near areas where flammable liquids are stored. 480C
Compressor Wiring:
1. Disconnect ground cable from vehicle’s battery.
2. Temporarily position the air compressor in the location where it will be mounted.
3. Route ground wire to the negative post of the battery or to an appropriate
grounding point and cut ground wire to length as needed.
4. Mount the 480C air compressor with the four sets of 13/64” (5 mm) bolts, nuts,
washers, and locking washers provided. Use of thread locker is recommended.
5. Use 3/8” NPT female to 1/4’ NPT male reducer to install compressor to open 1/4” NPT
port on 200 PSI-rated air tank.
Loading ...
Loading ...
Loading ...