Loading ...
Loading ...
Loading ...
5
Threaded Connectors
Teon tape should be used with threaded
SharkBite connectors to make a proper
seal.
Galvanized Tubing
SharkBite Universal ttings should not be
installed (threaded or push-to-connect)
on galvanized tubing.
SharkBite Soldering
When soldering is required near a
SharkBite Universal connection, make
all solder joints rst and then make the
SharkBite connections. Flame can cause
the pipe to reach high temperatures and
should not be used close to a SharkBite
Universal fitting.
SharkBite Fitting Reuse
SharkBite Universal ttings are intended
to be a permanent connection and are
not designed for repeated connection
and disconnection aer the initial install.
If a tting is installed incorrectly it can be
removed given that proper care is taken, as
detailed in the following steps.
1. SharkBite disconnect tongs or
SharkBite disconnect clips must be
used when removing the ttings.
2. The tting must be inspected by the
installer and be free of damage and
debris.
3. The initial pipe and the new pipe must
be clean and free from scratches and
burrs.
4. The insertion depth must be marked
on the pipe.
5. The connection must be pressure
tested and inspected by the installer to
verify that there are no leaks.
Working Pressure and
Temperature
SharkBite Universal ttings have a
maximum temperature of 200°F
maximum pressure 200 psi when used on
copper pipe. When used on PVC, CPVC,
PEX, PE-RT or HDPE refer to the maximum
pressure temperature rating of the pipe.
PEX Stieners
SharkBite Universal ttings (3/8" to 1")
come with an Integral PEX Stiener. 1/4"
(3/8" OD) ttings do not require PEX
stieners. PEX Stiener are required for
PEX, PE-RT and HDPE pipe. 2XL PEX
Stieners sold separately.
SB_InstallationInstructions_2020.indd 5SB_InstallationInstructions_2020.indd 5 5/13/20 2:37 PM5/13/20 2:37 PM
Loading ...