Loading ...
Loading ...
Loading ...
• Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use tool while
tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating power tools may result in
serious personal injury.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask
if operation is dusty. ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA/Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
Tool Specifi cations
MODEL DWFP12233
DESCRIPTION 18 GA Brad Nailer
ENGINE TYPE Oil–Free
OPERATING PRESSURE 70 – 120 psig (4.9 – 8.43kg/cm
2
)
MAXIMUM OPERATION
PRESSURE
120 psi (8.43 kg/cm
2
)
AIR CONSUMPTION AT A
RATE OF 60 FASTENERS
PER MINUTE*
1.15 cfm (32.6 lt/min) @
80 psi (5.62 kg/cm
2
)
FASTENER GAUGE 18 Gauge
FASTENER RANGE 5/8" -– 2-1/8" (15mm – 55mm)
MAGAZINE CAPACITY 100
LENGTH 11.3" (287mm)
WIDTH 3.2" (81mm)
HEIGHT 9.5" (241mm)
WEIGHT 3.1lbs. (1.4kg)
*To determine the appropriately sized air compressor, take the actual
rate at which the tool will be run and compare the required cfm (lt/min)
to the compressors free air delivery (cfm/ lt/min) at 80 psi (5.6 kg/cm
2
).
For example, if your fastener usage averages 30 fasteners per minute,
you need 50% of the tools cfm required to operate the tool at the
rate of 60 fasteners per minute. In this case, be sure that your air
compressor can deliver a minimum of 0.58 cfm (16.4 lt/min) at 80 psi
(5.6 kg/cm
2
) for optimum performance.
English
5
Loading ...
Loading ...
Loading ...