Loading ...
Loading ...
Loading ...
Menu item Description
PS SmartSwitch
On
O
Sets the printer to automatically switch to PS emulation when a print job
requires it, regardless of the default printer language
Notes:
• On is the factory default setting.
• When the O setting is used, the printer does not examine incoming
data.
• When the O setting is used, the printer uses PCL emulation if PCL
SmartSwitch is set to On. It uses the default printer language specified in
the Setup menu if PCL SmartSwitch is set to O.
NPA Mode
O
Auto
Sets the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol
Notes:
• Auto is the factory default setting.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Network Buer
Auto
3K to <maximum size allowed>
Sets the size of the network input buer
Notes:
• Auto is the factory default setting.
• The value can be changed in 1‑K increments.
• The maximum size allowed depends on the amount of memory in the
printer, the size of the other link buers, and whether Resource Save is
set to On or O.
• To increase the maximum size range for the Network Buer, disable or
reduce the size of the parallel, serial, and USB buers.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Job Buering
O
On
Auto
Temporarily stores jobs on the printer hard disk before printing. This menu only
appears if a formatted disk is installed.
Notes:
•
O
is the factory default setting.
• The On value
buers
jobs on the printer hard disk. This menu selection
appears only when a formatted disk is installed and is not defective.
• The Auto setting
buers
print jobs only if the printer is busy processing
data from another input port.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Mac Binary PS
On
O
Auto
Sets the printer to process Macintosh binary PostScript print jobs
Notes:
• Auto is the factory default setting.
• The O setting filters print jobs using the standard protocol.
• The On setting processes raw binary PostScript print jobs.
Understanding printer menus 110
Loading ...
Loading ...
Loading ...