Celestron 22129 90AZ-SR Refractor Telescope

INSTRUCTION MANUAL - Page 3

For 22129.

PDF File Manual, 8 pages, Read Online | Download pdf file

22129 photo
Loading ...
Loading ...
ENGLISH | 1
6
2
3
5
11
1
8
12
7
10
9
1. Telescope Tube
2. StarPointer Red Dot Finderscope
3. Smartphone Adapter (Smartphone not included)
4. 20 mm Eyepiece
5. Erect Image Diagonal
6. Focus Knob
7. Panning Handle/Altitude Clutch Knob
8. Tripod
9.
10 mm Eyepiece
10. Accessory Tray
11. Altazimuth Mount
12. 3x Barlow
SOLAR WARNING
Never look directly at the Sun with the naked eye or with a telescope unless you have the proper solar filter. Permanent and irreversible eye damage may result.
Never use your telescope to project an image of the Sun onto any surface. Internal heat build-up can damage the telescope and any accessories attached to it.
Never use an eyepiece solar fi lter or a Herschel wedge. Internal heat build-up inside the telescope can cause these devices to crack or break, allowing unfi ltered sunlight to pass through to the eye.
Do not leave the telescope unsupervised, especially when children or adults unfamiliar with the correct operating procedures of your telescope are present.
We recommend saving your telescope box so it can be used to store the telescope when it is not in use. Unpack the box carefully
as some parts are small. Use the parts list below to verify that all parts and accessories are present.
PARTS LIST
WHAT’S IN THE BOX
ASSEMBLING YOUR TELESCOPE
THE MOUNT
The mount and tripod come fully assembled, so setting it up is easy.
1. Remove the tripod and mount from the box.
2. Loosen the knobs at the bottom of each leg and extend the
inner section of the leg to the desired length. Tighten the knobs
to secure the legs, being careful not to over tighten.
3. Stand the tripod upright and pull the tripod legs apart until the
center brace snaps into place.
4. Place the threaded post on the bottom of the accessory tray
over the hole in the middle of the leg support bracket and turn
the entire tray clockwise until the tray sits fi rmly against the leg
brace (Fig. 1). (see manual of SKU# 22105).
5. Make sure the leg hinge bolts are secure by tightening the
thumbnuts at the top of each leg.
4
Loading ...
Loading ...
Loading ...