Loading ...
Loading ...
Loading ...
• Using an 13 mm wrench or adjustable wrench,
loosen the hex bolt located under the miter table.
See Figure 16. Adjust the miter table left or right
until the framing square and zero clearance throat
plate are parallel.
• Retighten the bolt securely and recheck the
fence-to-table alignment.
13mmHEXBOLT
FENCE
FENCE
MITER
TABLE
FRAMING
SQUARE
VIEWOFBLADE
SQUAREWITHFENCE
E
LOCKPLATE
MITER
LOCKHANDLE
Fig. 17
BoTroM VIEWOF MITERTABLE
Fig, 16
SQUARING THE SAW BLADE TO THE
FENCE
See Figures 17 - 20.
• Unplug your saw.
A WARNING: Failure to unplug your saw could
result in accidental starting causing possible
sedous personal injury.
Pull the saw arm all the way down and engage
the lock pin to hold the saw arm in transport
position.
Loosen the miter lock handle approximately
one-half turn.
Depress the miter lock plate and rotate the miter
table until the pointer on the control arm is
positioned at 0°.
Release the miter lock plate and securely tighten
the miter lock handle.
Lay a framing square flat on the miter table. Place
one leg of the square against the fence. Slide the
other leg of the square against the flat part of saw
blade,
Note: Make sure that the square contacts the flat
part of the saw blade, not the blade teeth.
FENCE
MRER FRAMING
TABLE SQUARE
VIEWOFBLADENOTSQUAREWITH
FENCE,ADJUSTMENTSAREREQUIRED
MITER FRAMING
TABLE SQUARE
BLADE
Fig. 18
BLADE
VIEWOFBLADENOTSQUAREWITH
FENCE,ADJUSTMENTSAREREQUIRED
Fig. 19
16
Loading ...
Loading ...
Loading ...