Loading ...
Loading ...
Loading ...
11
ENGLISH
Repairs
WARNING: To assure product SAFETY
and RELIABILITY, repairs, maintenance and adjustment
(including power cord repairs, and brush inspection
and replacement, when applicable) should be
performed by a BLACK+DECKER factory service center
or a BLACK+DECKER authorized service center. Always
use identical replacementparts.
Replacing Guard (Fig.C)
WARNING: Never operate appliance
without guard firmly in place. Damage or personal
injury couldresult.
Remove CurrentGuard
1. Remove the guard screw
15
shown in Fig.C.
2. Slide the guard
13
off.
Assembling the New Guard
1. Slide the guard into place as shown in Fig.C.
2. Replace and securely tighten the guard screw
15
.
Accessories
WARNING: Since accessories, other than
those offered by BLACK+DECKER, have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be
used with thisproduct.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service
center. If you need assistance in locating any accessory, please
contact BLACK+DECKER call 1-800-544-6986 .
Cleaning
WARNING: Blow dirt and dust out
of all air vents with clean, dry air at least once a
week. To minimize the risk of eye injury, always
wear ANSI Z87.1approved eye protection when
performingthisprocedure.
MAINTENANCE
WARNING: To reduce the risk of
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start‑up
can causeinjury.
Rewinding Spool from Bulk Line (Fig.J, K)
Use Only .065" (1.65 mm) Round
Diameter Line
Bulk line is also available for purchase from your localretailer.
NOTE: Hand wound spools from bulk line are likely to
become tangled more frequently than BLACK+DECKER
factory wound spools. For best results, factory wound spools
arerecommended.
1. Disconnect the plug from the power source.
2. Remove the empty spool from the appliance as
described in Replacing SpoolAssembly.
3. Remove any remaining cutting line from thespool.
4. Make a fold
23
at the end of the cutting line at about
3/4" (19 mm). Feed the cutting line into one of the line
anchoring slots
23
.
5. Insert the 3/4" (19 mm) end of the bulk line into the
hole
25
in the spool adjacent to the slot. Make sure the
line is pulled tight against thespool.
6. Wind the cutting line onto the spool in the direction of
the arrow on the spool. Make sure to wind the line on
neatly and in layers. Do notcrisscross.
7. When the wound cutting line reaches the recesses
26
,
cut theline.
8. Fit the spool onto the appliance as described in
Replacing SpoolAssembly.
NOTE: Make sure that cover is fully positioned, listen for
two audible clicks to ensure both release tabs are correctly
located. Power the appliance on. In a few seconds or less
you’ll hear the nylon line being cut automatically to the
properlength.
NOTE: Other replacement parts (guards, spool caps, etc.) are
available through authorized service centers. To find your
local service location call: 1-800-544-6986 or visit www.
blackanddecker.com.
WARNING: Never use solvents or other
harsh chemicals for cleaning the non‑metallic parts
of the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into
aliquid.
Loading ...
Loading ...
Loading ...