Loading ...
Loading ...
Loading ...
1. Place the freezer on a floor strong enough to support it fully loaded.
2. Remove all packaging material. This includes the foam base and all
adhesive tape holding the freezer accessories inside and outside.
3. Inspect and remove any remains of packing, tape or printed materials
before powering on the freezer.
1. Your freezer is designed for freestanding installation only.
It should not be recessed or built-in.
2. When moving the freezer, never tilt it more than a 45-degree angle. This
could damage the compressor and the sealed system.
3. If the freezer is tilted let it stand in an upright position for at least 24 hours
prior to plugging
in the unit. This is to allow the refrigerant to settle.
To assure your freezer works at the maximum efficiency it was designed
for, install in a location where there is proper air circulation, plumbing
and electrical connections.
The following are recommended clearances around the freezer:
Sides 4” (102mm)
Back 4” (102mm)
Top Do not block
Unpacking Your Freezer
Adjusting Your Freezer
Proper Air Circulation
Installing Your Freezer
5
1. Install on a level surface.
2. Allow 4 hours after installation before connecting to power source.
3. Allow unit to operate for 6–8 hours before placing food inside.
4. Clean interior with lukewarm water and mild detergent using sponge or
soft cloth. Be sure interior is dry before using.
Installing Your Freezer
Loading ...
Loading ...
Loading ...