Loading ...
Loading ...
Loading ...
CLEANING AND CARE
WARNING
Before cleaning or carrying out
maintenance, switch off the appliance,
disconnect the mains plug and turn off the
water tap. Your dishwasher can only be
repaired by an authorized service agent.
WARNING
All surfaces are susceptible to scratching.
Contact with unsuitable cleaning agents
can alter or discolor all surfaces.
WARNING
Keep the floor around your dishwasher
clean and dry to prevent any possible
injury. We recommend keeping your
dishwasher clean, empty and with door
cracked open to allow air to circulate in
case of any extended unused time.
The dishwasher door can be damaged by abrasive
cleaners, scouring pads, abrasive cloths. Cleaning the
machine at regular intervals prolongs the machine’s service
life.
Oil and limescale may accumulate in the machine’s
washing section. In case of such accumulation, fill the
detergent compartment without loading any dishes into the
appliance, select a program that runs at a high
temperature, and start the dishwasher. If not enough, use
special cleansing agents available on the market.
To clean any residue that has accumulated in the door
seals, wipe the seals regularly using a damp cloth.
Clean the appliance, filter, and spray arms at least once a
month. Unplug your machine and turn off its tap before
cleaning. Do not use hard materials when cleaning your
machine. Wipe with a soft cleaning material and a damp
cloth.
MATERIAL
Stainless
steel
Use a non-abrasive steel detergent and
apply with a soft lint-free cloth. To bring out
the natural luster, lightly wipe surface with
a water-dampened microfiber cloth
followed by a dry polishing chamois.
Always follow the grain of the stainless
steel.
Control
panel
Wipe with a damp cloth.
Dishwasher
racks
Wipe with a damp cloth.
MATERIAL
Interior Wipe interior, door edge, and rubber seal
with a damp cloth. If necessary, spray
household cleaner on the cloth. Do not
spray directly on the door. Use a
dishwasher cleaner (follow the instructions
on the package) or place 1 cup of vinegar
and 2 tbsp of baking soda in a container
on the middle rack and run a Heavy Wash
cycle.
Spray arms
Place under running water and use a
paper clip or similar to remove debris from
holes.
Filter
Clean with soap and water. For hard-to-
remove soils or calcium deposits, use a
soft brush. Do not use a wire brush or
scouring pad.
Gasket
Wipe with a damp cloth. Use warm soapy
water and a toothbrush. If mold or mildew
are present, spray with 3% hydrogen
peroxide.
SPRAY ARMS
The upper and lower spray arms can be removed for
cleaning.
Periodically check whether the holes for the upper and
lower spray arms are clogged. If you see any clogging,
remove the spray arms and clean them under running
water.
The impellers should be cleaned once a week for the
appliance to operate efficiently.
To remove the lower spray arm:
1) Pull the spray arm upwards (A, B).
2) Place under running water and use a paper clip or
similar to remove debris from holes.
Fig. 64
39
Loading ...
Loading ...
Loading ...