Loading ...
Loading ...
Loading ...
GROUNDING iNSTRUCTiONS
For a grounded, cord-connected washer:
This washer must be grounded. In the event of a malfunction
or breakdown, grounding will reduce the risk of electrical
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-grounding conductor and a grounding plug.
The plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local
codes and ordinances.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are
in doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance - if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
For a permanently connected washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or lead
on the appliance.
INSTALLATION INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
Before you start: remove shipping materials.
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
NOTE: To avoid floor damage during installation, set the washer
onto cardboard before moving across the floor.
iMPORTANT."
[] Be sure the foam shipping base has been removed from the
bottom of the washer as directed in the "Remove Shipping
Base and Packing Ring" section.
[] If foam shipping base has not been removed, be sure lid is
secured with tape before laying washer on its back.
[] Removing the foam shipping base is necessary for proper
operation.
REMOVE SHIPPING BASE
AND PACKING RING
. Remove shipping base
and packing ring
Place cardboard supports from shipping carton on floor
behind washer for support. Secure the lid with tape. Using
two or more people, tip the washer onto its back and place
on cardboard supports. Remove foam shipping base. Then,
set washer back upright, and remove the tape from the lid
so that you can open the lid and remove the foam packing
ring from the washer tub.
NOTE: Keep foam packing ring in case you need to move
the washer in the future.
CONNECT DRAIN HOSE
iMPORTANT: Proper connection of the drain hose helps
to avoid water leakage and damage to your floors. The drain
hose is connected to your washer and is stored inside the
washer cabinet.
fl. Remove drain hose from washer
cabinet
Gently pull hose out of back of washer cabinet from top until
end emerges.
iMPORTANT: Do not force excess drain hose back into rear
of washer.
6
Loading ...
Loading ...
Loading ...