Loading ...
2
Installation Instructions for Square and Linear Glass Guards
1
Loosen set-screws in TOP BRACKET and slide a
short and long piece of glass into it. (for square
glass kits, all panels will be equally sized)
2
Make sure the top edge of the glass is flush
with the bracket.
Ensure small silicone pad is in place on tip of
set screws, never secure with metal screw
directly to the glass. Over-tightening may
break glass!
Tighten set-screws until snug.
3
Repeat steps 1 and 2 for remaining three
corners.
4
Loosen set-screws and place BOTTOM
BRACKET onto glass. The rubber standoff
should position glass flush with bracket
edge. Secure all screws, making sure to not
over-tighten.
Secure remaining three bottom brackets
using the same procedure.
5
Carefully, using two people, flip the
assembly over. Gently set the glass guard
onto fire pit.
Top Bracket
WARNING: Always perform assembly on a
soft, non-abrasive surface. Two people are
recommended for assembly and installation!
HINT: For rectangular, square and round
burners it is recommended to assemble guard
upside down and flip over after it is fully
assembled.
HOT GLASS WILL CAUSE
BURNS
DO NOT TOUCH GLASS
UNTIL COOLED
NEVER ALLOW CHILDREN
TO TOUCH GLASS
Loading ...
Loading ...
Loading ...