Loading ...
Loading ...
Loading ...
Ca"re and Cleaning
l_ emal:er
Light bulb
replacement
Tile icemaker has a light bulb in tile top of tile
storage bin. To replace it, open the bin door
and tollow these inst_ uctions:
1. UnI)lug tile icemaker or disconnect power.
2. Remove tile 3 screws that hold tile cutter
grid cover in place. Reach behind tile
control panel and pull tile light bulb down.
3. Replace with a 12-volt wedge base-type bulb
(a utom otive #917). I,ocate the light bulb
receptacle at the top behind the control
panel. Mign the flat edge of the light bulb
with the receptacle and snap the bulb
into place.
4. Replace the cutter grid cover with the
.'4screws.
5. Plug in tile icemaker or reconnect power.
Vacation
and moving
To shut down the icemaJcer:
1. Unplug tile icemaker or disconnect power,
2. Remove all ice fl'om tile storage bin.
3. Nl/tlt ot1 tile water supply.
4. Remove the 2 screws in the lower access
panel and tile 2 screws fl'om tile base grille
area of tile fl'ont panel support. Pull torward
to i'emove tile lower access panel.
U L.
5. Disconnect tile inlet and outlet lines to
water wdve. Allow these lines to drain and
then reconnect to the \:dve.
6. Replace tile lower access panel and screws.
Drain water fl'om water reservoir bv
removing the drain cap. Also, remove water
from drain line. i,eave tile door open
to allow the icemaker and water reservoir
to dry out completely.
7. Betore using again, clean the icemaker
and storage bin.
IMPORTANT: Every time the icemaJ_er is
turned off, you MUST clean the icemaker
system with the Nickel Safe Ice Machine
Clemmr. See Care and Cleaning--Icemaker
system section for instructions.
8. Plug in tile icemaker or reconnect power.
NOTE: All components of tile icemaker are
permanently lubricated at tile factory. They
should not require any additional oiling
throughout tile n(mnal lite of tile machine.
Jc_#_TerS#
Osmosis
system
IMPORTANT: Tile perfimnance of tile
icemaker mav be affected when connected to
a Revet_e Osmosis system, An RO system may
also reduce water pressure and attect tile fill
cycle, which is dependent on time and flow.
The reduced water pressm'e (less than 20 psi)
inav cause tile reservoir not to fill and flush
properly during tile ice making cycle.
Do not use copper tubing when the icemaker is
cmmected to a Reverse Osmosis water system.
13
Loading ...
Loading ...
Loading ...