Loading ...
Loading ...
Loading ...
CYCLE OPTIONS
Press to START
or resume a wash
cycle
If the door is opened during a cycle or the power is interrupted, the START button LED
ashes. Cycle will not resume until door is closed and START is pressed.
Press to CANCEL
wash cycle
Close the door rmly. Press and hold CANCEL for 3 seconds. The dishwasher starts a
2-minute drain (if needed). Let dishwasher drain completely.
CONTROL PURPOSE
COMMENTS
High
Temp
Raises main wash temperature to improve cleaning for
loads containing tough, baked-on food.
Auto
PowerBlast™
Normal
Raises
main wash
temperature to
a minimum of
129F (53.9 C).
Press and hold
the button for 3
seconds to turn
on/off sound.
0:00 to 1:00 0 – 3.3
(0 – 12.5)
Sanitize Sanitizes dishes and glassware in accordance with NSF
International NSF/ANSI Standard 184 for Residential
Dishwashers. Certied residential dishwashers are
not intended for licensed food establishments. Only
sanitizing cycles have been designed to meet the
requirements of the NSF/ANSI 184 performance
standard for soil removal and for sanitization efcacy.
There is no intention, either directly or indirectly, that
all cycles on a NSF/ANSI 184 certied dishwasher
meet the NSF/ANSI 184 performance standard for soil
removal and for sanitization efcacy. The Sani Rinse
indicator glows at the end of the cycle if the Sani Rinse
option was successfully completed. If your load did not
properly sanitize, the indicator light will ash at the end
of the cycle. This can happen if cycle is interrupted or
if the water does not reach the required temperature.
The light goes off when you open and close the door or
press CANCEL.
Auto
PowerBlast™
Normal
Raises the main
wash temperate
to145°F
(62.8°C) and
the nal rinse
temperature to
(156°F (69°C).
0:15 to 1:30 0 – 3.7
(0 – 14.0)
Heated
Dry
Dries dishes with heat. Use option with rinse aid to
provide best drying results. Plastic items are less likely
to deform when loaded in top rack. Use Heat Dry for
optimum drying performance. Turn option off for an air
dry.
Auto
PowerBlast™
Normal
Quick
Light
Uses a heating
element to
speed drying
times. Heat Dry
option defaults
to On when
any cycle is
selected except
for Quick and
Rinse.
0:11 to 0:46
4-Hour
Delay
Runs dishwasher at a later time or during off-peak
electrical hours. Select a wash cycle and options. Press
Delay button to delay the cycle by 4 hours. Close door
rmly. Press START.
NOTE: Any time the door is opened (such as, to add
a dish), the START keypad must be touched again to
resume the delay countdown.
Available
with any
cycle
Delays start of
a cycle by 4
hours.
Control
Lock
(Hold 3 Sec)
Use the Control Lock option to avoid unintended use of dishwasher between cycles and/or during cycles. To turn on
Control Lock, press and hold Control Lock for 3 seconds. Control Lock light will stay on for a short time, indicating
that it is activated. When the Lock indicator is lit, all buttons are disabled. If you press any button while your
dishwasher is locked, the light ashes 3 times. The dishwasher door can still be opened/closed while the controls
are locked.
To turn off Control Lock, press and hold Control Lock for 3 seconds. Control Lock light turns off.
ADDED
TIME TO
CYCLE
OPTIONS
CAN BE
SELECTED
WITH
WHAT IT
DOES
ADDED
WATER
GALLONS
(LITERS)
Loading ...
Loading ...
Loading ...