Loading ...
Loading ...
Loading ...
6
humidity value is at least 3% (10% recommended) lower than the inlet humidity reading.
2) In Humidistat Mode, if you see “wet controller” icon illuminating after running the
dehumidifier for a while, it means the dehumidifier has got the room humidity down to the
set point and the dehumidifier enters into standby mode.
Defrosting Icon: The dehumidifier begins to defrost when the frost has accumulated
on the interior of the dehumidifier. When the dehumidifier is defrosting, the fan is running,
but the compressor is not, the defrost icon is flashing. The dehumidifying function will cease
until the frost has melted. When defrosting is complete, the defrosting Icon will disappear
and the dehumidifier begins to dehumidify again automatically.
Note: The frequent defrost process indicates that the room temperature is too cold.
Therefore, if the room temperature is lower than 60°F, please consider adding heat to
promote proper drying.
Fan Icon: The fan icon illuminates when the fan is running.
Water Droplets Icon: The water droplets icon illuminates when the compressor kicks in,
which means the dehumidifier is dehumidifying. When the compressor delays to start due to
the 3-minutes delay system, this icon flickers.
Caution: Water tank must place in right position,other wise will cause the waterfull alarm.
Timer Icon: Timer icon illuminates when the timer function is enabled.
(2) Understand the Control Buttons
Power Button: Press to turn the dehumidifier ON or OFF.
Up Button: Press ⬆ to increase the set-point of humidity level or timer.
Down Button: Press ⬇ to decrease the set-point of humidity level or timer.
Timing/Function Button: Press once to check the settings. Press and hold for 3 seconds to
enter Timer setting system.
5. General Operation Instructions
(1) Turn the dehumidifier on
Press the Power Switch to turn the dehumidifier on.
(2) Set a desired humidity percentage value
Press ⬆ or ⬇ button to set your desired humidity percentage value between 10%-98% in
increment of 1%. 40%-60% is a general humidity setting guide. After selected the target
value, press Timing/Function Button to confirm your setting, or let the setting be registered
automatically after 5 seconds of no operations on the control panel.
Loading ...
Loading ...
Loading ...