Loading ...
Loading ...
Loading ...
8
Pole Assembly
1. With the cam lock open, insert the end of the sweeper head
into the bottom of the pole assembly. They should snap
together with an audible “click” (Fig. 6).
2. Close the cam lock to secure the sweeper head in place
(Fig. 7).
3. To adjust the length of the pole, loosen the locking collar
by turning clockwise. Then extend the pole to your desired
length (Fig. 8).
4. To secure the pole in place, twist the locking collar counter-
clockwise until it is tight.
Fig. 6
Sweeper head
Pole assembly
Cam lock
Fig. 7
Cam lock
Fig. 8
Locking collar
5. Attach the auxiliary handle onto its mounting point on the
pole using the included bolt and handle knob (Fig. 9).
6. Adjust the auxiliary handle to your desired angle before
locking it in place by tightening the handle knob (Fig. 10).
NOTE: The auxiliary handle can also be flipped down.
However, it is recommended to use the auxiliary handle
during operation.
7. To disassemble the weed sweeper, open the cam lock
(Fig. 7). Press the locking tabs on either side of the pole
and pull the sweeper head out from the pole assembly
(Fig. 11).
Fig. 9
Auxiliary handle
Handle knob
Bolt
Fig. 10
Auxiliary handle
Handle knob
Fig. 11
Locking tabs (x2)
Loading ...
Loading ...
Loading ...