Loading ...
Loading ...
Loading ...
7
3. The battery will take approximately 1 hr and 20 mins to
charge. The battery indicator LEDs will cycle on one by
one during the charging process. Unplug the charger
immediately when all 3 LEDs are illuminated.
mCAUTION! FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from the
outlet first, then disconnect the battery from the charger.
mWARNING! This charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
4. Timely recharging of the battery will help prolong the
battery’s life. Recharge the battery pack when you notice a
drop in the equipment’s power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the battery.
Assembly
mWARNING! Do not insert the battery until assembly is
complete. Failure to comply could result in accidental starting
and serious personal injury.
mWARNING! The product must be fully assembled before
operation. Do not use a product that is only partially assembled
or assembled with damaged parts.
Follow the assembly instructions step-by-step and use the
figures provided as a visual guide to assemble the product.
Fig. 2
Battery
indicators
Sweeper Head Assembly
1. Snap the guard onto the sweeper head, then secure using
the two included thread forming screws (Fig. 3).
2. To attach a brush, first insert the tightening rod through the
hole in the spindle to lock it in place (Fig. 4).
3. Insert the small washer over the spindle. Then place either
the nylon or wire brush followed by the big washer over
the spindle as well. Using the wing nut, tighten counter-
clockwise by hand until the components are secured. Once
tightened, remove the tightening rod to allow the spindle to
rotate freely (Fig. 5).
Fig. 3
Guard
Thread
forming
screw
Fig. 4
Spindle
Tightening rod
Fig. 5
Brush
Big
Washer
Wing nut
Small
washer
Spindle
Loading ...
Loading ...
Loading ...