Loading ...
Loading ...
Loading ...
www.SereneLifeHome.com
17
8. Using the extention and rotation feature on the Connecting pole
Extend or shorten the length of the telescopic pole(Fig. 1a/Item 8) by loosening
(Fig. 9) the Clamp coupling for telescopic pole (Fig. 1a/Item 11) and pull in or push
out the lower section to achieve the correct height as shown below. Then tighten
the coupling.
8.1 Adjusting the angle of pruner in the vertical direction (Fig. 7a-7b)
Press The Rotating button (Fig. 1a/Item 12) on both sides for the angle of tilt
adjustment. Now you can set the pruner to the required tilt. Release the button
and allow the pruner to lock into position to x the angle of tilt. Four dierent
locking angles are possible. The adjusting range is from 0° to 90°.
8.2 Adjusting the angle of pruner in the horizontal direction (Fig. 8)
Holding The Connecting pole with one hand, and The pruner bracket
(Fig. 1a/Item 6) with the other. Rotate the pruner brack etrmly to the required
angle. The adjusting range is from -90° to +90°.
9. Operation the Pole Pruner
To close the blade activate the handle safety lock-o (Fig. 1a/Item 9) by pushing it
forward and pressing the handle ON/OFF switch (Fig. 1a/Item 10) at the same
time. To open the blade, let go of the handle ON/OFF switch (Fig. 1a /Item 10).
10. Cleaning, maintenance and ordering of spare parts
Warning! Always wear protective gloves when using, adjusting or cleaning
the machine.
10.1 Cleaning
• Keep all safety devices, air vents and the motor housing free of dirt and dust as
far as possible. Wipe the equipment with a clean cloth or blow it with compressed
air at low pressure.
• We recommend that you clean the device immediately each time you have
nished using it.
• Clean the equipment regularly with a moist cloth and some soft soap. Do not
use cleaning agents or solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the device.
• A few drops of oil (e.g. sewing machine oil) will improve the cutting performance
of the blades, but never apply any grease to the blades.
Loading ...
Loading ...
Loading ...