Loading ...
Loading ...
Loading ...
www.SereneLifeHome.com
15
5. Before starting the equipment
5.1 Installing the battery (Fig. 3a/3b)
Press the both side of the battery pack as shown in Fig. 3a and push the battery
pack into the mount provided. When the battery pack is positioned as in Fig.
3b, make sure that the battery pack latch in place! To remove the battery pack,
proceed in reverse order.
5.2 Charging the battery (Fig. 4)
1. Take the battery pack out of the equipment. Do this by pressing the both side of
the battery pack.
2. Check that your mains voltage is the same as that marked on the charger rating
plate. Connect the power plug of the charging unit to a socket outlet, then insert
the charging unit to battery pack. The red LED was always light.
3. The charging unit will end the charging automatically when the battery is fully
charged (after approx. 3~5 hours). The green LED then lights up and the red LED
light out.
The battery pack can become a little warm during the charging. This is normal.
If the battery pack fails to charge, the green and red LED in the battery lights
up. Check:
• whether there is voltage at the socket outlet
• whether there is good contact at the charging contacts
If the battery pack still fails to charge, send
• the Battery charger
• and the battery pack to our customer service center.
To ensure that the battery pack provides long service, you should take care to
recharge it promptly. You must recharge the battery pack when you notice that
the power of the cordless pruner drops. Never fully discharge the battery pack.
This will cause it to develop a defect.
Loading ...
Loading ...
Loading ...