Loading ...
Loading ...
Loading ...
9EN
For 25mm spacer (door proud install – side
spacers)
Rotate the top half so that the 25 marking
on the top half is facing up . Pushing the two
halves together firmly should make a 25mm
thick assembly.
To secure this to your fridge, peel the
protective layer off the adhesive strips, and
attach the spacer to your fridge side in the
below four locations (two per side)
For 30mm spacer (door flush install – side
spacers / rear spacer - all install types)
Rotate the top half so that the 30 marking
on the top half is facing up . Pushing the two
halves together firmly should make a 30mm
thick assembly.
To secure this to your fridge, peel the
protective layer off the adhesive strips, and
attach the spacer to your fridge side in the
below four locations (two per side) plus two
at the rear of your fridge as shown.
Recommended dimensions for the door flush
installation
Before installation, ensure cabinetry opening is
not smaller than the minimum sizes specified for
your chosen install type. A rear chimney is not
necessary for this fridge model. The specified
ventilation cross-sections must be adhered to
in order to ensure the correct functioning of the
appliance.
D1
Cabinetry
Depth
W1
Cabinetry
Width
H1
Cabinetry
Height
724 mm 950 mm 1800 mm
Installing the product to the niche
1. There are six spacers included to help you
keep your fridge perfectly centred in the
cabinetry opening and with enough space
behind to vent correctly.
To setup the 25mm/30mm spacer blocks
to the correct size, you can join the two
spacer block halves together in one of two
directions.
Each spacer block has two components:
Top half (part A): curved dome with 25 and
30 printed on top
Bottom half (part B): Is a flatter piece with
two long adhesive strips on its underside
plus two clip arms on its top side
1795mm
1800mm
724mm
704mm
950mm
896mm
Part A
UP
Shown
by
arrows
Part B
50
mm
300mm
100
mm
100
mm
300mm
300mm
Loading ...
Loading ...
Loading ...