Loading ...
Loading ...
Loading ...
8 www.electrolux.com
5. If you find your refrigerator rocks from corner
to corner, it means your floor is uneven. Find
a piece of plastic or hardboard etc. and
pack it firmly under the roller.
6. You may now need to fine-tune the
installation by repeating steps 3, 4 and 5.
7. When you have the appliance in its final
position, it needs to be stabilised. Wind the
stability foot under the door hinge down to
the floor until it just makes contact with the
floor. Lift the front of the appliance to take
the weight off the stability foot, then turn it
half a turn further to ensure firm contact with
the floor. Wind the large height adjusting
nut back up to ensure all the weight is now
on the front stability foot. Wind the large
height adjusting nut back up to ensure all the
weight is now on the front stability foot.
8. Repeat step 7 for the stability foot on the
handle side. Whenever you need to move
the appliance, be sure to wind the feet back
up so that the appliance can roll freely and
be sure to reset it when reinstalling.
9. Plug your refrigerator straight into its own
power point and never use a double
adapter. If you need to roll the refrigerator
to get to the plug, remember to raise the
stability foot first.
10. Before you put any food in your refrigerator,
it’s recommended you leave it on for 2 or 3
hours to check it is running properly.
Fridge door flush with the cabinetry
Side clearance must be 30mm either side of
the fridge body, to have the fridge doors siting
flush with the kitchen cabinetry
Minimum cabinetry opening (WxDxH) :
950mm x 724mm x 1800mm
Note : Top gap all 5 mm.
1. Roll the refrigerator into place.
The rollers are designed for forward or
backward movement only. They are not
castors. Moving the refrigerator sideways
may damage your floor and the rollers.
Before moving your refrigerator ensure
height adjusting nut and the stability foot
are fully wound up off the floor.
2. Wind the large height adjusting nut under
door hinge down until the refrigerator is
tilted back by 10mm (see diagram).
3. Wind the large height adjusting nut on the
handle side down until the refrigerator is
level and stable. If you have difficulty
winding the nut or height adjusting foot
down, have someone tilt the refrigerator
back so you have better access.
4. Check the alignment of the refrigerator to
the surrounding cupboards to see if it is
level. You can adjust the level as detailed in
step 2 and 3.
stability foot
wound up
nut
For adjustment
where floor is not level
10-33mm
stability foot
wound down
Front view
30 mm
30 mm 30 mm
Note : Spacers supplied to assist
Loading ...
Loading ...
Loading ...