Loading ...
Loading ...
Loading ...
- Place the switch in the "MED" position to select medium
power.
- Place the switch in the "MAX" position to select maximum
power.
Place the switch in the "0" position to turn the appliance off.
Adjusting the thermostat
When the room has reached the required temperature, turn the
thermostat slowly anticlockwise until the indicator light goes out
(or until you hear a "click") and no further. The set temperature
will then be regulated automatically and kept constant by the
thermostat.
Frost protection function
With the thermostat in position and the switches in max posi-
tion, the appliance maintains the room at a temperature of
about 5˚C, preventing freezing with minimum energy consump-
tion.
Models with 24-hour timer
Using the timer
If you wish to use the timer, position the switch in the middle
position (Fig. 9).
Setting the correct time
Check the time on your watch. If for example it is 4.00 pm.
(16.00), turn the dial in a clockwise direction until the number 16
is lined up with the triangular pointer (fig.11). N.B.: Never turn
the dial in an anti-clockwise direction!
The timer is in effect an electric clock and works only if the plug
is connected to the power supply. Whenever the plug is discon-
nected or there is a power failure, the clock must be re-set.
To program the timer
1) Set the operating times (fig. 12) by pushing in the notches
on the dial corresponding to the period required (each
notch represents 15 mins.)
2) Make sure that the timer indicates the correct time (see
instructions on setting the correct time) .
3) Turn the radiatior on and set it to the heat setting and tem-
perature level on the thermostat as required.
Once programmed in this way, the appliance will repeat the pre-
established program every day, if the selector is in the posi-
tion.
Timer override
If you wish to override the timer settings, push the timer switch
to position 1 (fig.9) manual (timer override). To return to timed
operation push the switch back to the middle position (fig.9).
NOTE: if the timer switch is at the 0 position (fig.9), the heater is
off and will not operate).
TURBO HEATING
Some models are fitted with a heating fan which heats the room
more quickly.
To turn this function on, push the button into the position.
Important: the fan is not intended to be used for extended
periods. A safety device cuts in and switches off the appliance if
it overheats due to an accumulation of dust on the air intake and
output grills. To restart it, unplug from the mains and leave the
appliance to cool down. Clean the air intake and output grills
with a vacuum cleaner, then replug into the mains and turn on
again.
MAINTENANCE
Before carrying out any operation on the radiator, unplug from
the electric mains and wait for it to cool. The oil-filled electric
radiator requires no particular maintenance. It is sufficient to
remove the dust with a soft, dry cloth. Never use abrasive pow-
ders or solvents. If necessary remove concentrations of dirt using
a vacuum cleaner.
5708014900_05_1217
*