Loading ...
Loading ...
Loading ...
Before you call for service...
Troubleshooting Tips
Problem
Salty tasting or
brown/yellow colored
water after installation
Brown/yellow
colored water
Resin beads showing
up in drinking water
and sink
Possible Causes
Unit not sanitized
What To Do
• Complete the Sanitizotion procedures on page !2.
At completion of recharge cgcle (approx. 2 hrs), run water
from faucets to purge the saltg water.
Low water pressure Check pressure.
Drainheight 8' or less,pressureshould be minimum of 20 psi.
Drainheight above 8', pressureshould be minimum of 50 psi.
Restricted drain hose Clean and reconnect hose.
Check for kinks indrain line.
Unit was idle for a period of time • Complete the Sanitization Procedureson page 12.
Cracked distributor Callfor service.
Sounds you might hear Running water from the unit ,,Thisis normal.
into a drain during recharge
Water has air bubbles Air in sgstem after installation • Will go awag after it runs for a while.
and is cloudy
Error Code on control Wiring mag have worked loose
in the control
,,Seepage !6 for details.
• Unplug transformer.
,, Removecontrol cover,release clips on side.
Check for loose/incorrect wiring connections to electronic
board or switch. Reconnectas required.
Reassemblecontrol cover.
PluginTransformer.
Wait six minutes for Error Codeto reappear.
If ErrorCode reappears,call for service.
22
Loading ...
Loading ...
Loading ...