Loading ...
Loading ...
Loading ...
11
1 -
EN
1 -
5 - PROBLEMS
Incidents may arise when using your washing machine :
If the screen shows one of the following errors and an alarm beeps, before calling Customer Service:
check whether:
the water tap is
open.
5.1
check whether:
- the lid is not clo-
sed correctly.
- the drum is block
5.2
check whether:
The pump filter is
clogged ; clean the
filter
(paragraph 4.3).
5.3
Note on operation - this is not an incident :
The programme time
decreases or increases
during the wash
This is not a fault. The length of time displayed at the start of the programme is
updated according to the load in the machine (automatic weighing). This gua-
rantees perfect washing results and water and energy consumption appropriate
to the load. This is normal. The spin safety and anti-foam systems may extend
the initial programme time displayed.
Here are a few points to check :
Problems : Causes / Remedies :
The washing machine will not start : - The appliance is not plugged in or there is a power cut.
- You haven't pressed the "Start/Pause" button
.
- You have programmed a delayed start.
- See problems 5.1 and 5.2
The linen is not or not sufficiently spun : - You have selected a programme without spin drying or with
limited spin drying.
- The spin safety system has detected poor distribution of the
washing in the drum : unfold the linen and programme another
spin cycle.
- Check the height of the curved drain part
(Diagram 1.3)
.
H
A puddle of water forms on the floor : First remove the plug from the socket and turn off the water
supply.
- Check that the seals are fitted and the connectors are tigh-
tened
(Diagram 1.2)
.
- Check the curved part is positioned correctly
(Diagram
1.3)
.
H
G
Strong vibrations when spin drying : - The washing machine has not been released correctly
(Diagram 1.1.3)
.
- The floor is not level
(paragraph 1.4)
.
The machine does not drain : - You have programmed "Full drum stop".
- The drain hose is bent or squashed
(Diagram 1.3)
.
- See problem 5.3
The lid does not open : - The programme has not yet finished.
-Wait until the temperature inside the machine drops.
The drum is blocked : - If you have access, check that a small item of linen is not trap-
ped between the drum and the tank, by removing part
from the bottom of the drum
(Diagram 4.2)
.
- See problem 5.2
A
The drum doors open very slowly (on
machines fitted with gently opening doors) :
- Your machine has not operated for a long time.
- It is located in too cold a position.
- Detergent residue (powder) is blocking the hinges.
- in all cases, everything returns to normal after the doors have
opened initially.
The display is switched off at the end of the
programme:
- The display is automatically switched off 5 minutes after the
end of your programme in order to save energy. Press any but-
ton to restart the display.
Loading ...
Loading ...
Loading ...