Loading ...
Loading ...
Loading ...
_] PROVIDE ADEQUATE GAS SUPPLY
Your range is designed to operate at a pressure
of 4" of water column on natural gas or, ff designed
for LP gas (propane or butane), 10" of water
column_ Make sure you are supplying your range
with the type of gas for which it is designed. This
range is convertible for use on natural or propane
gas. If you decide to use this range on LP gas,
conversion must be made by a qualified LP
installer before attempting to operate the range
on that gas.
For proper operation, the pressure of natural gas
supplied to the regulator must be between 4" and
13" of water column. For LP gas, the pressure
supplied must be between 10" and 13" of water
column. When checking for proper operation of
the regulator, the inlet pressure must be at least
1" greater than the operating (manifold) pressure
as given above. The pressure regulator located
at the inlet of the range manifold must remain in
the supply line regardless of whether na_u-al or
LP gas is being used. A flexible metal appliance
connector used to connect the range to the gas
supply line should have an I.D. of 1/2" and be
5 feet in length for ease of installation, tn Canada,
flexible connectors must be single wall metal
connectom no longer than 6 feet m length.
i i i iii ii iiiiiiii1,111,11111,111,1
[] COHHECT THE RANGE TO GAS
Shut off the main gas supply valve before
disconnecting the old range and leave it off until
new hook-up has been completed. Don't forget
to relight the pilot on other gas appliances when
you turn the gas back on.
Because hard piping restricts movement of the
range, the use of an A.Gdk-certified flexible
metal appliance connector is recommended
unless local codes require a hard-piped connection.
Never use an old connector when installing a
new range. If the hard piping method is used,
you must carefully align the pipe; the range
cannot be moved after the connection is made.
To prevent gas leaks, put pipe joint compound
on, or wrap pipe thread tape with Teflon*
around, all male (external) pipe threads.
*Teflon: Registered trademark of DuPont
GasPlpeand ElectricOutlet Locutions
for ModelsEquippedwith Sealed Burners
This area allows
for flush range
installation with
through-the*wall
connection of pipe
stub/shut-off valve
and rear wall
120V outlet.
Shortest
connaet£or%
from hard pipe
stub location to
range hookup
Thts area allows for
flush range Installation
wHh through-the-floor
connection of pipe
stub/shuFoff valve.
6W' r-k
GasPipe and Electric Outlet Locations for
Models Equipped with Standard Twin Burners
This area allows
for flush range
installation with
through-the-wall
connection of pipe
stub/shut-off valve
and rear wall
120V outlet..
_>,_ Shortest
connection
from hard pipe
stub location to
range hookup,
This area allows
for flushrange
instatlalJon with
through-the-floor
connection of ptpe
stub/shut-off valve.
(continued n_xt page)
37
Loading ...
Loading ...
Loading ...