Loading ...
Loading ...
Loading ...
26 Operation
Connecting the projector to the Internet
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the
other end to the RJ45 port.
2. Make sure the menu type is Advanced. See Using the menus on page 23 for how to switch
to the Advanced OSD menu.
3. Go to the Advanced menu - System > Network Settings menu.
4. Highlight Wired LAN and then press OK. The Wired LAN page is displayed.
5. Press / to highlight DHCP and press / to select On.
6. Press / to highlight Apply and press OK.
7. Go back to the Network page.
8. Press / to highlight AMX Device Discovery and press / to select On or Off. When
AMX Device Discovery is On, the projector can be detected by AMX controller.
9. Please wait for around 15 - 20 seconds, and then re-enter the Wired LAN page.
10. The IP Address, Subnet Mask, Default Gateway, and DNS Server settings will be displayed.
Note down the IP address displayed in the IP Address row.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press / to highlight DHCP and press / to select Off.
3. Contact your ITS administrator for information on the IP Address, Subnet Mask, Default
Gateway, and DNS Server settings.
4. Press / to select the item you want to modify and press OK.
5. Press / to move the cursor and then press / to enter the value.
6. To save the setting, press OK. If you do not want to save the setting, press BACK.
7. Press / to highlight Apply and press OK.
8. Press BACK to return to Wired LAN page, press / to highlight AMX Device Discovery
and press / to select On or Off.
9. Press BACK to exit the menu.
When connecting the RJ45 cable, avoid coiling and intertwining the cable as it may cause signal noise or
interruption.
If the IP Address still does not display, contact your ITS administrator.
Loading ...
Loading ...
Loading ...