Loading ...
Loading ...
Loading ...
25 Operation
Changing the password
1. Go to Advanced menu - System > Security Settings > Password. Press OK. The Password
page appears.
2. Highlight Change Password and press OK.
3. Enter the old password.
• If the password is correct, another message Input New Password appears.
• If the password is incorrect, the password error message will appear, and the message
Input Current Password appears for your retry. You can press BACK to cancel the change
or try another password.
4. Enter a new password.
5. Confirm the new password by re-entering the new password.
Disabling the password function
To disable password protection, go to Advanced menu - System > Security Settings >
Password > Power On Lock and press OK and / to select Off. The message Input Password
appears. Enter the current password.
• If the password is correct, the OSD menu will disappear. You will not have to enter the
password next time turning on the projector.
• If the password is incorrect, the password error message will appear, and the message
Input Current Password appears for your retry. You can press BACK to cancel the change
or try another password.
Switching input signal
The projector can be connected to multiple devices at the
same time. However, it can only display one full screen at
a time. When starting up, the projector automatically
searches for the available signals.
Be sure the Advanced menu - Display > Auto Source
Search menu is On if you want the projector to
automatically search for the signals.
To manually select the source:
1. Press SOURCE. A source selection bar appears.
2. Press / until your desired signal is selected and press OK.
Once detected, the selected source information will appear at the corner of the screen for
seconds. If there is multiple equipment connected to the projector, repeat steps 1-2 to
search for another signal.
Though the password function is disabled, you need to keep the old password in hand should you ever need
to re-activate the password function by entering the old password.
• The brightness level of the projected image will change accordingly when you switch between different
input signals.
• For best display picture results, you should select and use an input signal which outputs at the
projector’s native resolution. Any other resolutions will be scaled by the projector depending upon the
“aspect ratio” setting, which may cause some image distortion or loss of picture clarity. See
Aspect
Ratio on page 36
.
Source
Loading ...
Loading ...
Loading ...