Loading ...
Loading ...
Loading ...
perlick customer service (800)558-5592 | 5
PERLICK RESIDENTIAL UNDERCOUNTER USE & CARE GUIDE
Changing the Lower Compartment Temperature:
1. Press and hold the SET button until the display shows St1
with”F” ashing.
2. Press SET again to display the lower compartment’s current
temperature (“F” will continue to ash).
3. Use the UP or DOWN arrow key to scroll to the desired
temperature. The controller will memorize the new
temperature.
Changing the Upper Compartment Temperature:
1. Press and hold the SET button until the display shows St1
with”F” ashing. Press the DOWN arrow once; the display will
read St2.
2. Press SET again to display the upper compartment’s current
temperature (“F” will continue to ash).
3. Use the UP or DOWN arrow key to scroll to the desired
temperature. The controller will memorize the new
temperature.
NOTE: Dependent on the model and conguration, the controllers have
been programmed to only allow a lower compartment temperature
adjustment range as specied within the chart below. The upper
compartment range is not limited, but should always be kept within
the specied range shown in the table for the upper compartment. See
the chart below for the specied range allowed for your unit.
Signature Series – Dual-Zone Units
Model Range (F)
HP24Z Upper 30° - 42°F / Lower -10° - 15°F
HP24C Upper 45° - 65°F / Lower 33° - 42°F
HP24D Upper 51° - 65°F / Lower 45° - 55°F
To Start A Manual Defrost (HP24Z Models Only)
Press and hold the DEFROST button (melting snowake) for 3-5
seconds. Melting snowake will illuminate.
15”, 24” Single Zone, 24” Shallow Depth, and ADA Controls
To Set Target Temperature
Press and release the SET button. Display will show the current
temperature setpoint.
To Change Setpoint Temperature
1. Press and hold the SET button until the display shows the
current setpoint temperature with the “F” ashing.
2. Use the UP and DOWN arrow button to scroll to the desired
temperature.
To Start A Manual Defrost (Freezer Models Only)
Press the DEFROST button (melting snowake).
To See Maximum Stored Temperature
Press the UP arrow button to see the maximum stored tempera-
ture. To reset the maximum stored temperature, while displayed,
press and hold the SET button until ‘rst’ ashes in the display.
To See Minimum Stored Temperature
Press the DOWN arrow button to see the minimum stored tem-
perature. To reset the minimum stored temperature, while dis-
played, press and hold the SET button until ‘rst’ ashes in the
display.
On/O
Press the ON/OFF button to turn the unit on or o.
NOTE: Dependent on the model and conguration, the controllers
have been programmed to only allow a temperature adjustment
within a specied range. See the chart to right for the specied range
allowed for your unit.
TOUCHSCREEN CONTROL OPERATION REFRIGERATOR MODELS
Loading ...
Loading ...
Loading ...