Loading ...
Loading ...
Loading ...
Stops
Leaks Water
Is Noisy
Fills with
the Wrong
Temperature
Water
. Unevenly distributed load. Redistribute the load, close the lid and pnll knob
out. Check for leveling. Be sure water level is acceptable for load size.
* Plug cord into live electrical outlet.
* Check fuse or reset circuit breaker.
* Turn the control lmob to proper cycle and pull knob out to start the washer.
If equipped with buttons, be sure they are fully depressed.
* Close lid and pull control knob out to start the washer. For your safety, wash-
er will not fill, agitate or spin unless lid is closed.
* This may be a pause or soak period in the cycle. Wait briefly and it may start.
° Make sure hose connections are tight.
, Make sure end of drain hose is correctly inserted and secured to drain
facility.
° Avoid extended soaking - soak for 30 minutes or less.
° Avoid overloading.
* Be sure washer is leveled properly as outlined in installation manual.
° Weak floors can cause vibration and walking.
° Be sure rubber feet are installed on leveling legs.
* Turn both faucets on _ally.
* If equipped with a temperature selector knob, be sure it is set directly on a
temperature setting and not between settings.
° Make sure temperature selection is correct.
° Make sure hoses are connected to correct faucets and inlet connections.
Flush water line before filling washer.
° Check the water heater. It should be set to deliver a mininmn_ 120°F (49°C)
hot water at the tap. Also check water heater capacity and recovery rate.
° Disconnect hoses and clean screens. Hose filter screens may be plugged.
S. c_tstomers llsing TTY f!_r dea_ hearing impaired or speech impaired, call 1-800-688-2080o
12
Loading ...
Loading ...