Loading ...
Loading ...
Loading ...
Installing Your Refrigerator
How to Connect the Water Supply
WARNING
To reduce the risk of injury or death, follow basic precautions, including the following:
•Read all instructions before installing device.
• DO NOT attempt installation if instructions are not understood or if they are beyond personal skill level.
• Observe all local codes and ordinances.
• DO NOT service device unless specifically recommended in owner's manual or published user-repair
instructions.
• Disconnect power to unit prior to installing device.
CAUTION
To avoid property damage or possible injury, follow basic precautions, including the
following;
• Consult a plumber to connect copper tubing to household plumbing to assure compliance with local codes and
ordinances.
• Confirm water pressure to water valve is between 20 and 100 pounds per square inch. If water filter is installed,
water pressure to water valve must be a minimum of 35 pounds per square inch.
•DO NOT use a self-piercing, or 3/16"saddle valve! Both reduce water flow, become clogged with time, and
may cause leaks if repair is attempted.
• Tighten nuts by hand to prevent cross threading. Finish tightening nuts with pliers and wrenches. Do not
overtighten.
• Wait 24 hours before placing unit into final position to check and correct any water leaks.
Materials Needed
1/4" outer diameter flexible copper tubing
NOTE: Add 8' to tubing length needed
to reach water supply for creation of
service loop.
•Shut-off valve (requires a 1/4" hole to
be drilled into water supply before
valve attachment)
• Adjustable wrench
114"hex nut driver
Create service loop with _ [ _ Slide brass nut over sleeve
ltubing using care to avoid _Jand screw nut into inletport.
kinksintubing. _0 _ [Tightennutwithwrench. 1
.;j IMpoRtANt:DONOTove,ighten.
Cross threading may occur.
"I
_. Remove plastic cap from c'_
re'water valve inlet port. 6
I3 Place brass nut (A) and A\ B
sleeve (B) on copper _ _LX I
tube end as illustrate ' .J
"x
Place end of copper tubing into_ _ _-\_ hours. Correct leaks, if necessary. J
4watervalveinletport. Shape _]ll I 7M°nit°rwaterc°nnecti°nf°r24
tubing slightly-OO NOT KINK- HI
so that tubing feeds straight _ll l
into inlet port. _ _J
Loading ...
Loading ...
Loading ...